Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Universal Joint, Drive/Propeller Shaft > Component Information > Service and Repair > Service Notes > Page 2470

Page 5
background image

Fig. 18 Aligning bearing cups & journals

ASSEMBLY
BALL SOCKET & CONSTANT VELOCITY JOINT

During assembly, make sure that marks made during disassembly, are aligned to maintain balance.
1. To install centering ball onto stud, use tool C-4365 or equivalent, and drive ball until it can be seen that ball has seated firmly against shoulder at

base of stud.

2. To install cross assembly, install one bearing cup part way into one side of yoke and turn this yoke to the bottom. Insert cross into yoke so that the

trunnion seats into bearing. Install opposite bearing cup part way. Make sure that both cross journals are started straight into both bearing cups.

Fig. 19 Relieving binding condition at point A

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Universal Joint, Drive/Propeller Shaft > Component Information > Service and Repair > Service Notes > Page 2470

[PREV PAGE] [NEXT PAGE]