911 Targa (996) F6-3.6L (2004)
-
Angle drill
-
Drill bit, ø 3 mm
-
Mounting lever, e.g. special tool 9182
-
Sheetmetal screw with hexagon head (5.0 x 20)
-
Washer
-
Support, e.g. wooden block 50 x 30 x 20 mm
Removal procedure:
-
Drill sealing ring on face side (refer to drawing).
-
Screw sheetmetal screw with washer approximately 5 mm into the bore.
-
Position mounting lever on the sheetmetal screw; place support between the mounting lever and crankcase.
-
Lever crankshaft sealing ring out of the crankcase.
Installation
1. Insert new sealing ring using special tool 9610 (insertion tool):
a. Place assembly sleeve on crankshaft journal.
b. Thoroughly lubricate the crankshaft journal, assembly sleeve and sealing lip.
Note;
-
Do not lubricate outer diameter of sealing ring; it must be fitted dry.
c. Position sealing ring by hand and push off the assembly sleeve onto the crankshaft journal.
d. Remove assembly sleeve.
e. Position hexagon-head bolt (M16 x 1.5 x 60) and outer part of special tool and insert sealing ring as far as it will go.
2. Fit belt pulley.
Note;
-
Check whether there are foreign objects in the drive belt grooves of the pulley.
3. Tighten hexagon-head bolt using the socket wrench insert 9594; simultaneously hold with retaining device 9593.