911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
Work on the roll-over protection system must only be performed with the ignition key withdrawn.
-
Attention: Do not begin assembly work until after a waiting time of 1 minute has elapsed.
-
Tools or other objects must not be placed in the extension area of the roll-over protection system.
-
Remove the roll-over bar modules only after the roll-over bar has been extended (triggered).
It is not permissible to perform repairs on the roll-over bar modules.
The roll-over bar modules must be replaced in the event of visible damage or pressure marks.
After assembly work on the roll-over protection system - but at least every 2 years - the function of the roll-over protection system must be tested by
triggering it via the diagnostic interface of the PIWIS tester 9718.
Only perform the function test on the roll-over protection system with the hardtop and cap removed and the convertible top open.
Removing roll-over bar
Mechanical emergency triggering of the roll-over protection system
If the roll-over bar modules cannot be triggered via the diagnostic interface, mechanical emergency triggering is possible.
1. Unclip cover upwards -1-.
CAUTION: Danger of injury when working on the roll-over protection system.
-
The movement range of the roll-over protection system must be kept clear.
2. Press with a screwdriver against the upper edge of the pawl -2-. The roll-over protection system will be released.
Removing roll-over bar module