911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Spacers 9651
24. Slide preassembled cylinder housing onto the threaded bolt.
Fitting preassembled cylinder housing
Notice
Loose parts in crankcase
Risk of engine damage
-
Cover crankcase bores with a clean cloth.
25. Fit the piston pin and the piston-pin circlip for the outer pistons from the inside (through the middle cylinder bore).
Piston pins for outer pistons
26. Remove the cloth at the crankcase bores.
27. Once you have fitted the piston-pin circlips, slide the cylinder housing as far as the spacers 9651 and fix in place using two threaded sleeves from
the special tool set of retaining nuts P140.
28. Prepare middle cylinder sleeve. Fit new O-ring and apply a generous amount of special grease (Part No. 000.043.205.10).