911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Steering-wheel holder
7.1.
Move steering wheel into center position.
Secure the steering wheel in center position using the steering-wheel holder -A-.
7.2.
Remove universal joint.
Removing and installing universal joint
Loosen screw -1- on the universal joint -2- and remove it. Pull universal joint -2- off the steering spindle -3-.
Make sure not to pull the red lug -4- down as well because this will only increase the amount of assembly work required.
8. Pull connector off the range adjustment sensor (left side of vehicle only).
9. Remove pressure and return lines at the steering gear.
Information
^
Before the feed and return lines are loosened, place a suitable container underneath to collect steering fluid.
^
Wear protective goggles and gloves.