924 S L4-2479cc 2.5L (1986)
The guide pipe and connecting pipe can be joined by special tool "9621".
Special Tool "9261" ensures the necessary clearance of 0.8-0.2 mm between the clamping sleeves and the housing at the coupler connection. The full
holding force of the coupler can only be guaranteed in this position.
When assembling, the special tool "9261" must be used on the coupler and the connection pipe or guide pipe pushed into the coupler against stop.
Drive Cable Adjustment
The drive cable control distance from the connecting pipe to the end of the square edged clamping sleeve (distance "A") must be 284 +/- 1.5 mm in the
"roof unlocked" position.
If this distance is not reached, the length can be adjusted by turning the drive cable in the guide pipe. Turning clockwise will increase the distance and
vice versa.
Important:
In so doing, both lifting elements must be run into the element housings against stop.
The transfer box located in the middle of the roof for the old lifting roof version is omitted on the new version. The drive cable is now one piece.
