Cayenne GTS (9PA) V8-4.8L (2008)
5. Bolt impact hammer no. 3 to adapter 9757 -1-.
6. Fit impact hammer and puller onto the thread of the injector and carefully remove injector by hitting it straight on a number of times. (Remember
that if any part of the injector body is damaged during removal, the complete injector must be replaced.)
Replacing Teflon sealing ring on high-pressure fuel injector
NOTE:
Incorrect handling of injectors
-
Leaks in combustion chamber
-
Teflon sealing rings must always be replaced after removal and before refitting injectors.
-
Do not replace Teflon sealing rings until just before fitting the injector.
-
Install injector immediately after replacing the Teflon sealing ring.
INFORMATION: The tool numbers refer to the individual parts of the tools in the repair kit T10133 and the supplement set T10133/11-15 (unless
indicated otherwise).
Installation position of Teflon sealing ring: -arrow-
1. Remove high-pressure fuel injector.
2. Clean fuel injector carefully using a plastic brush (or cloth) and acetone or solvent naphtha. Hold Teflon sealing ring gently using a pointed-nose
pliers and carefully pull off Teflon sealing ring -1-. Do not scratch valve body.
3. Also clean sealing ring groove in the area of the sealing ring. Remove any deposits (coking).