Cayenne S (9PA) V8-4.5L (2003)
11. Pull the relevant cable out to the rear.
Note!
^
The -screw plug (arrow)- of the brake cables obscures the view of the Quickfit. The Quickfit is positioned at approximately 3 o'clock to the
right and approximately 9 o'clock to the left.
^
The brake discs do not have to be removed in order to disengage the brake cables.
12. Remove the -screw plug (arrow)- at the brake disc.
13. Remove the brake cable. Do not loosen the snap ring! To do this, insert a -screwdriver between the sleeve of the brake cable and the wheel bearing
housing-.
14. Pull the -sleeve of the cable- as far as possible out of the wheel bearing housing.
15. Push the cable gently into the brake drum. Use a small screwdriver-inserted through the brake disc opening- to press the safety spring and hexagon
on the spreading lever upwards and at the same time pull the brake cable out of the brake drum.
Installation