Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1357002.png)
1. Remove outermost tie rod ends with press-out tool T10187. When pressing out, screw fastening nut on flush (protects the ball joint thread).
2. Remove -fastening screws- from heat insulation plate (steering transmission/steering shaft). If it is a Cayenne with Servotronic, pull off connector.
3. Remove fastening screw of -universal joint of steering shaft (Arrow)- (push universal joint slightly upwards).
4. Release rear securing mechanism of front axle drive (right-hand side of vehicle). Lift -front axle drive with a suitable lift- (use wooden block or
rubber base in order to prevent slipping. Take out fastening screw and lift front axle drive only to the extent that bearing eye above front axle
carrier is accessible (when doing so, do not push cardan shaft as far as it will go).
5. Re-insert -fastening screw (Arrow)- (easier to access). Transmission remains in the raised position and lift can be removed.
1. Release -feed and return lines (arrows)- (collect steering fluid in a suitable container). Close lines and open taps with suitable plugs.
2. Remove -fastening screws of steering transmission (arrows)-.
3. Unclip -coolant hoses- from holders to facilitate removal of steering transmission and pull up (steering transmission illustrated transparently here).
4. Remove heat insulation plate and push -steering transmission- towards the right out of the suspension subframe mounting points and turn towards
