Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1364003.png)
^
The arrow denotes the clamp lug.
^
When fitting the large clamps, it is essential to observe the following installation position (right/left). The clamps must be fitted in the correct
position. Place the clamp pliers 74 on the clamp lug and lightly clamp. It should still be possible to easily turn the clamps. Check the position of
the clamp once more, correcting if necessary, and then compress the clamp lug fully.
^
The clamp of the left joint boot must be clamped on the steering gear so that the clamp lug -arrow is in line with the steering shaft! Failure to
observe this can lead to constrictions in the area of the supply and return lines.
^
The clamp of the right joint boot must be clamped on the steering gear so that the clamp lug -arrow points horizontally at the front axle carrier (
suspension subframe) in the direction of travel. Failure to observe this can lead to constrictions in the area of the heat shield.
^
Check vehicle toe and adjust if necessary. Tightening torque 70 Nm (52 ft. lbs.) (locknut on tie rod).
