Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Installing rear spring strut
Caution:
Increased risk of accident due to raising the wheel carrier incorrectly. When filling the air spring struts, the vehicle lifts.
-
Injury and material damage possible.
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
intermediate layer (hard rubber).
-
Do not damage the brake cover plate.
Information
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
intermediate layer (hard rubber).
-
Do not damage the brake cover plate.
-
The entire threaded parts of the axle must be tightened in vehicle position! Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift! Dimension -X-, from lower edge of wing to middle of axle 506 mm ±10 mm corresponds to
vehicle position!
-
Carry out a visual inspection of all parts!
-
Replace self-locking nuts!
-
If a new spring strut is fitted, it must be pre-filled to 3 bar in its original packaging.
-
Replace all expansion screws (screws which are fitted with torque angle tightening procedure)!
-
Use correct tightening torques and torque angle!
1. Insert spring strut into vehicle.