Torque specifications
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Information › Torque specifications
SuspensionTorque specifications · page 1 of 2
TORQUE SPECIFICATIONS
| A | Self - locking nut |
| B | Flange bolt |
| C | Castle nut |
| D | Caliper bracket mounting bolts |
| E | Spindle nut |
| F | Self - locking nut |
| G | Damper mounting bolt |
| H | Self - locking nut |
| I | Self - locking nut |
| J | Flange bolt |
| K | Self - locking nut |
| L | Flange nut |
| M | Flange bolt |
| N | Self - locking nut |
| O | Self - locking nut |
| P | Damper mounting nut |
CAUTION: Fit new self - locking nuts after removal.
- The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushings are tightened.
- Torque the castle nut to the lower torque specification, then tighten sufficiently to permit alignment with the next available pin hole. Do not align the nut by loosening.
- Wipe off the grease before tightening the nut at the ball joint.
Parts & tools for this job For Rover 600
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.