Information

Make

Rover

Model

600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition

Section

Contents › Information

ElectricalInformation

INFORMATION

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)	2
SPECIAL TOOLS	3
FAULT FINDING	4
Microcheck	4
Tips and precautions	4
Five - step fault finding	6
HOW TO USE THIS SECTION	8
REPAIR PROCEDURES FOR WIRING HARNESSSES	10
Repair Techniques	10
TYPICAL WIRING HARNESS FAULTS	11
Pinched	11
Chafed	11
Cut or Broken	12
Overheated (exterior heat)	12
Overheated (short circuit)	13
Mis - routed	13
Not long enough	14
Wire crossed in connector	14
Wire missing from connector	15
TYPICAL EARTH FAULTS	16
Paint on body contact point	16
Corroded	16
Loose	17
Disconnected	17
Crimped over insulation	18
WIRING CONNECTOR PROBING TECHNIQUES	19
Introduction	19
CONNECTOR TYPES AND CONNECTOR PROBING	20
TYPICAL WIRING CONNECTOR FAULTS	22
Crimped over insulation	22
Backed out of connector	22
Bent or damaged terminal	23
Corroded or wet terminal	23
Loose	24
Disconnected	24

RELAY AND CONTROL UNIT LOCATIONS

RELAY AND CONTROL UNIT LOCATIONS

2

WIRE HARNESS AND EARTH LOCATIONS

WIRE HARNESS AND EARTH LOCATIONS	1
FUSES *	15
Engine compartment fuse/relay box	15
Passenger compartment fuse/relay box	18
Engine compartment abs fuse/relay box	21
POWER DISTRIBUTION	22
Circuit identification (LHD)	22
Circuit identification (RHD)	30
EARTH DISTRIBUTION	37
Circuit identification	37
Circuit identification (RHD)	42

Original page

View full sizeFit to page

18 Electrical