Power steering pump (page 2 of 2)

Refit

1. Clean mating faces of steering pump and coolant pump.
2. Position steering pump and support bracket to coolant pump housing.
3. Align steering pump to coolant pump drive lugs.
4. Fit but do not tighten 2 long bolts securing steering pump to coolant pump housing.
5. Fit 3 bolts securing steering pump to coolant pump housing.
6. Tighten steering pump to coolant pump housing bolts to 25 Nm.
7. Connect feed hose to steering pump and tighten clip.
8. Connect high pressure hose to steering pump, use new sealing washers.
9. Tighten high pressure hose banjo bolt to 20 Nm.
10. Position pulley to steering pump, fit and tighten bolts.
11. Fit alternator. See ELECTRICAL, Repairs.
12. Tighten pulley to steering pump bolts to 25 Nm.
13. Connect battery earth lead.
14. Refill power steering reservoir and bleed system. See Adjustments.