Leon Mk1
Gear lever and protective cover: repairing |
Note!
Lubricate the points of support and the sliding surfaces with grease -G 052 142 A2-. |
1 - | Spring washer |
q | Removing and installing → Fig. |
2 - | Bush |
3 - | Compression spring |
4 - | Bush |
5 - | Torx screw |
q | 5 Nm |
6 - | Cover |
7 - | Damper |
8 - | Halfshell bearing |
9 - | Gear lever guide |
10 - | Dampening washer |
11 - | Gasket |
q | Between the protective cover and the bodywork |
q | Self-adhesive |
q | Stick it onto the protective cover |
12 - | Bolt |
q | 25 Nm |
13 - | Support |
q | Fixed onto the bodywork |
14 - | Hexagon nut |
q | 25 Nm |
15 - | Gear stick |
16 - | Damper |
17 - | Gear stick protective cover |
18 - | Bearing bush |
19 - | Support bolt |
20 - | Guide bush |
21 - | Compression spring |
q | Assembly → Fig. |
22 - | Selector bracket |
23 - | Torx screw |
q | 5 Nm |
24 - | Lower plate |
q | To disassemble, open the flanges |
q | Replace if lugs are broken |
25 - | Track selection cable |
q | It connects to the selector bracket |
q | Installation position → Chapter |
26 - | Connection cable for gears |
q | Fit into the gear lever guide |
q | Installation position → Chapter |
27 - | Spring washer |
28 - | Bolt |
q | 25 Nm |
29 - | Bearing bush |
q | Fit in only one position |
30 - | Spring washer |
|