seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gearbox housing and clutch housing: repairs > < Gear change prongs: Disassembling and assembling

Leon Mk1

checking and completing
checking and completing
–  Raise the vehicle.
–  Diesel engine vehicles: Remove the centre sound insulation → Exterior body installation work; Rep. gr.50 .
   
–  Loosen oil level test bolt -arrow-.
  Note
Oil level is correct when the oil reaches the bottom edge of filling hole.
Oil specification for gears → Chapter.
–  If the oil level is not correct, complete oil level.
–  Unscrew control lid, start engine and let the gears work with engaged gear for about 2 minutes.
–  Stop the engine, remove oil cap and check level again, top up if necessary.
–  Tighten the gearbox oil level control cap to a torque of 25 Nm.
–  Install the middle soundproofing.
  V39-1959

Gearbox housing and clutch housing: repairs > < Gear change prongs: Disassembling and assembling