SEAT Workshop Service and Repair Manuals

ATF: replace Check the tool and equipment equivalence table according to the applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Tray -T20173-, see equivalent → Anchor t  Protective glasses

–  Switch off engine   Note It is essential to take into account all of the test instructions and conditions in the section “Automatic gearbox: check the ATF level” → Chapter –  Put the vehicle on a 4-post lift or over a workshop pit, to ensure it is completely horizontal. –  Remove the central soundproofing → Booklet1.   Note t  Take into account the arrangements for the correct elimination of residues. t  The engine must not be started nor the vehicle towed without ATF.   WARNING t  When working close to the radiator always maintain a minimum safety distance away from the fan. Failure to do so could result in an accident. t  The fan may start on its own. –  Fit tray -T20173- beneath gearbox.   WARNING Use protective goggles.

–  Undo the drain plug -A-. –  Let the ATF come out.

–  Unscrew the overflow tube -C- and let the ATF drain out.

–  Fit the overflow tube -C-.

Component	Nm
Overflow tube -C- on the oil pan	1

–  Add 3 litres of ATF (as shown in the → Spare parts catalogue) through the filler hose. –  Start the engine and select all the gear lever positions one after another for approximately 10 seconds each. –  Then, check and correct the ATF level → Chapter.