SEAT Workshop Service and Repair Manuals

14 pin connector cable harness: removing and fitting

A  -	14 pin connector

B  -	Cable harness to 14 pin connector

q	Designation and layout of the solenoid valves and layout of the cable harness → Chapter

Note t  Cleaning norms when working on automatic gearbox. → Chapter t  General repair instructions. → Chapter

Cable harness with 14 pin connector: removing   WARNING Take all measures concerning the disconnection of the battery → Electrical system; Rep. gr. 27. –  Remove cover -1- above the battery. To do this press the release tab -arrow-.

–  Disconnect battery earth strap-arrow-with the ignition switched off. –  Remove oil pan → Chapter. –  Remove oil strainer → Chapter. –  Remove the selection unit → Chapter. If the gearbox is in place:

–  Disconnect the 14 pin connector -A- from the gearbox connector.

–  Unscrew the attachment bolt from the 14 pin connector on the outer part of the gearbox housing. –  With due care, take out the connector along with the cable harness -D- from the gearbox housing. Cable harness with 14 pin connector: fitting Installation is carried out in reverse order, noting the following: –  Replace the O-ring on the connector. –  Moisten the O-ring with ATF. –  Press in the connector with the O-ring on the gearbox as far as possible. Tightening torque

Component	Nm
Securing bolt for the 14 terminal connector	5,5