seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gearbox input speed senderG182 : removing and fitting > < 14 pin connector cable harness: removing and fitting

Leon Mk1

8 terminal cable harness and integrated Gearbox oil temperature senderG93: removing and fitting
   
8 terminal cable harness and integrated Gearbox oil temperature sender -G93-: removing and fitting
A  - 8 pin connector
B  - Cable harness to 8 pin connector
q   Components on the cable harness → Chapter

  Note
t  Cleaning norms when working on automatic gearbox. → Chapter
t  General repair instructions. → Chapter
   
Cable harness with 8 pin connector: removing
  WARNING
Take all measures concerning the disconnection of the battery → Electrical system; Rep. gr. 27.
–  Remove cover -1- above the battery. To do this press the release tab -arrow-.
  A27-0190
–  Disconnect battery earth strap-arrow-with the ignition switched off.
–  Remove oil pan → Chapter.
–  Remove oil strainer → Chapter.
–  Remove the selection unit → Chapter.
  A10-1612
If the gearbox is in place:
  A37-0569
–  Disconnect the 8 pin connector -B- from the gearbox connector.
–  Unscrew the attachment bolt from the 8 pin connector on the outer part of the gearbox housing.
–  With due care, take out the connector along with the cable harness -C- from the gearbox housing.
Cable harness with 8 pin connector: fitting
Installation is carried out in reverse order, noting the following:
–  Replace the O-ring on the connector.
–  Moisten the O-ring with ATF.
–  Press in the connector with the O-ring on the gearbox as far as possible.
Tightening torque
  A38-0106
ComponentNm
Securing bolt for the 8 terminal connector5,5

   

Gearbox input speed senderG182 : removing and fitting > < 14 pin connector cable harness: removing and fitting