seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gearbox output speed senderG195 : removing and fitting > < 8 terminal cable harness and integrated Gearbox oil temperature senderG93: removing and fitting

Leon Mk1

Gearbox input speed senderG182 : removing and fitting
Gearbox input speed sender -G182 -: removing and fitting
  Note
t  Rules of cleanliness to be taken into account when working on the automatic gearbox → Chapter.
t  General repair instructions. → Chapter
   
Gearbox input speed sender -G182 -: removing
  WARNING
Take all measures concerning the disconnection of the battery → Electrical system; Rep. gr. 27 .
–  Remove cover -1- above the battery. To do this press the release tab -arrow-.
  A27-0190
–  Disconnect battery earth strap-arrow-with the ignition switched off.
–  Remove oil pan → Chapter.
–  Remove oil strainer → Chapter.
–  Remove the selection unit → Chapter.
  A10-1612
–  Unscrew the bolt -1-.
–  Extract the Gearbox input speed sender -G182 - from the gearbox along with the cable -A-.
Gearbox input speed sender -G182 -: fitting
Installation is carried out in reverse order, noting the following:
–  Carefully pressing, insert the Gearbox input speed sender -G182- into the gearbox all the way.
  A38-0106
ComponentNm
Gearbox input speed sender -G182- to the gearbox, bolt M65,5

   

Gearbox output speed senderG195 : removing and fitting > < 8 terminal cable harness and integrated Gearbox oil temperature senderG93: removing and fitting