seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing the selector housing > < Removing and installing oil sump

Leon Mk1

Removing and installing ATF strainer
Removing and installing ATF strainer
  Note
t  Cleaning norms when working on automatic gearbox. → Chapter
t  General repair instructions. → Chapter
Remove the oil strainer
–  Remove oil pan → Chapter.
   
–  Unscrew the bolts for the oil strainer -arrows-.
–  Remove the oil strainer -A- from the selection unit.
Fit the oil strainer
–  Apply a thin layer of ATF to the gaskets located on the intake collar of the oil strainer (reverse).
  Note
If the gaskets on the reverse of the oil strainer to the selection unit are in bad condition or released from the strainer then the strainer must be replaced.
–  Fit the oil strainer -A- on the selection unit and tighten it.
  A38-0102
ComponentNm
Oil strainer to the selection unit, 3 M6 bolts -arrows-11

–  Install oil pan → .
–  Fill with ATF, check and correct ATF level → Chapter.
   

Removing and installing the selector housing > < Removing and installing oil sump