–
| Tighten hexagon nut to 120 Nm, measure friction torque → Chapter and if necessary increase tightening torque until specified friction torque is attained. |
B - | Torque wrench - turn anticlockwise for screwing on. Use 3/4" to 1/2" reducer if necessary. |
C - | Protective jaw covers |
Increase torque setting slowly and check friction torque at regular intervals. |
If the prescribed friction torque is exceeded, the spacer sleeve must be renewed and the adjustment repeated. A spacer sleeve which has been compressed too much cannot be reused. |
|
|
|