Leon Mk1
| Gear change prongs: Repair |
| 1 - | Rubber dampers |
| q | Removed and fitted on the control rod by hand |
| 2 - | Selector rod with selector fork for 1st and 2nd gears |
| 3 - | Selector rod with selector fork for 3rd and 4th gear |
| 4 - | Selector rod with selector fork for 5th and 6th gear |
| q | It is also used as a mount for the reverse gear prong in certain gearboxes. |
| 5 - | Selector fork for reverse gear |
| q | On the shaft for the reverse gear prong → Fig. |
| q | The ball bearing is disregarded for gearboxes that have been manufactured from week 10/06 → Item |
| q | It is pressed down step by step |
| q | The reverse gear prong has been adapted |
| q | When the shaft for the selector fork for reverse gear is not required on the selection shaft, fitted on the gear fork of the 5th / 6th gear → Fig.. |
| q | Identification of different types of reverse gear selector forks → Fig. |
| q | Assign the component according to the → Spare parts catalogue |
| 6 - | Ball sleeve |
| q | Remove → Fig. |
| q | Driving in → Fig. |
| q | The ball bearing is disregarded for gearboxes that have been manufactured from week 10/06 → Item |
| q | It is pressed down step by step |
| Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. |
| Special tools and workshop equipment required |
| t | Hose clamp -T20129-, see equivalent → Anchor |
| t | Extractor kit -T20140-, see equivalent → Anchor |
| t | Kit (case) -U-40200A-, see equivalent → Anchor |
|
|
| Dim. „a“ mm | Selector fork for reverse gear | Mounting |
| 24 | With ball bearing | On the shaft for the reverse gear prong → Fig. |
| 18 | Without ball bearing | |
| 15 | Without ball bearing | On the selector rod with selector fork for 5th and 6th gear → Fig. |
|
|
|
|
