Leon Mk1
Gear change prongs: Repair |
1 - | Rubber dampers |
q | Removed and fitted on the control rod by hand |
2 - | Selector rod with selector fork for 1st and 2nd gears |
3 - | Selector rod with selector fork for 3rd and 4th gear |
4 - | Selector rod with selector fork for 5th and 6th gear |
q | It is also used as a mount for the reverse gear prong in certain gearboxes. |
5 - | Selector fork for reverse gear |
q | On the shaft for the reverse gear prong → Fig. |
q | The ball bearing is disregarded for gearboxes that have been manufactured from week 10/06 → Item |
q | It is pressed down step by step |
q | The reverse gear prong has been adapted |
q | When the shaft for the selector fork for reverse gear is not required on the selection shaft, fitted on the gear fork of the 5th / 6th gear → Fig.. |
q | Identification of different types of reverse gear selector forks → Fig. |
q | Assign the component according to the → Spare parts catalogue |
6 - | Ball sleeve |
q | Remove → Fig. |
q | Driving in → Fig. |
q | The ball bearing is disregarded for gearboxes that have been manufactured from week 10/06 → Item |
q | It is pressed down step by step |
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. |
Special tools and workshop equipment required |
t | Hose clamp -T20129 -, see equivalent → Anchor |
t | Extractor kit -T20140 -, see equivalent → Anchor |
t | Kit (case) -U-40200A -, see equivalent → Anchor |
|
Dim. „a“ mm | Selector fork for reverse gear | Mounting |
24 | With ball bearing | On the shaft for the reverse gear prong → Fig. |
18 | Without ball bearing | |
15 | Without ball bearing | On the selector rod with selector fork for 5th and 6th gear → Fig. |
|
|