Renewing input shaft seal

Make

SEAT

Model

Leon Mk1

Section

Gearbox,mechanics,gears,shafts,internal operation › Input shaft › Renewing input shaft seal

Power transmissionRenewing input shaft seal

Procedure –  Remove gearbox. –  Remove slave cylinder with release bearing → Chapter.

–  Lever out seal for input shaft using lever -T20143/1-.   Note Do not damage running surface of input shaft for oil seal.

–  Half-fill space between sealing lip and dust lip -arrow- with sealing grease -G 052 128 A1-. –  Lightly moisten outer circumference of oil seal with gear oil.

–  Drive seal in flush using thrust piece -T10233-. –  Install slave cylinder with release bearing → Chapter. –  Install gearbox .

01 Transmission

The same page in: Leon Mk2.