Output shaft

Make

SEAT

Model

Leon Mk1

Section

6-speed manual gearbox 0A6 › Gearbox,mechanics,gears,shafts,internal operation › Output shaft

Power transmissionOutput shaft

Assembly overview - output shaft for reverse gear

  Note

t	Output shaft is not available as a spare part.

t	If tapered roller bearing is renewed, install new shims of the same thickness as the old ones.

1 -	Clutch housing

2 -	Oil deflector ring

3 -

Shim

q	Note thickness

q	Will be damaged when removed; renew

4 -	Tapered roller bearing outer race

q	Pulling off → Fig.

q	Driving in → Fig.

5 -	Inner ring and roller bearing unit

q	Driving out → Fig.

q	Driving in → Fig.

6 -	Dished washer

q	Pulling off → Fig.

q	Driving in → Fig.

7 -	Output shaft

q	For reverse gear

q	Bearing of synchromeshed gear for reverse gear by sleeve bearing or by roller bearing → Item and needle bearing → Item

q	Distinguishing → Fig.

8 -	Roller bearing

q	For synchromeshed gear for reverse gear

q	Not used with all gearboxes, in which case sleeve bearing for synchromeshed gear for reverse gear → Item

9 -	Needle bearing

q	For synchromeshed gear for reverse gear

q	Not used with all gearboxes, in which case sleeve bearing for synchromeshed gear for reverse gear → Item

10 -	Reverse gear synchromeshed gear

q	Different internal diameter for sleeve bearing and bearing by roller bearing → Item and needle bearing → Item

q	Removing and installing stop ring and spring → Chapter.

11 -	Reverse gear locking collar

q	With synchronising ring:

12 -	Synchromesh assembly of the reverse gear

q	Press off together with reverse gear synchromeshed gear → Item after removing retaining ring → Fig..

q	Installation position: the stop for the reverse gear locking collar -arrow- must face the safety ring.

q	Driving in → Fig.

13 -	Retaining ring

14 -	Inner ring and roller bearing unit

q	Driving out → Fig.

q	Driving in → Fig.

15 -	Tapered roller bearing outer race

q	Pulling off → Fig.

q	Driving in → Fig.

16 -

Shim

q	Note thickness

q	Will be damaged when removed; renew

17 -	Gearbox housing

Differentiation of bearing for synchromeshed gear for reverse gear

Bearing for reverse gear synchromeshed gear
Sleeve bearing	Circumferential groove -arrow 1- in area of hole -arrow 2-
Bearing by roller bearing and needle bearing	No circumferential groove -arrow 1- in area of hole -arrow 2-

01 Transmission

The same page in: Leon Mk2.