Leon Mk1
| Adjustment chart |
Note| It is necessary to adjust both output shafts or differential only if components have been renewed which have a direct effect on the adjustment of the gearbox. The following table must be consulted to avoid unnecessary adjustment work: |
| To be adjusted: | ||||
| Output shaft for 1st - 4th gear → Chapter | Output shaft for 5th, 6th and reverse gears → Chapter | Differential → Chapter | ||
| Components renewed: | Gearbox | x | x | x |
| clutch housing | x | x | x | |
| Output shaft for 1st - 4th gear | x | |||
| Output shaft for 5th, 6th and reverse gears | x | |||
| Differential casing | x | |||
| Tapered roller bearings for 1st to 4th gear output shaft | x | |||
| Tapered roller bearing for 5th/6th and reverse gear output shaft | x | |||
| Tapered roller bearings for differential | x | |||