SEAT Workshop Service and Repair Manuals > Leon Mk1 > 7-speed dual clutch gearbox 0AM | Gearbox,mechanics,gears,shafts,internal operation | Dismantling and assembling outer input shaft

Dismantling and assembling outer input shaft

Overview

1 -	Outer input shaft

2 -	Retaining plate with screws: The lettering shows toward the gears, the smooth surface to the bearing

3 -	Bearings: Pressing off → Fig.; pressing on → Fig.

4 -	Determining thickness of retaining ring → Fig.

Outer input shaft - pressing off bearing

The bearing is destroyed during pressing off and must be renewed.

Outer input shaft - pressing on new bearing to stop

–	Make sure that bearing is only pressed on over inner ring.

l	Lettering on plate faces towards gears.

Installing retaining ring

Objective is to secure bearing with retaining ring without play. To achieve this, you must select ring that fits into groove without play.

–	Insert rings one after another sideways into groove.

–	Select ring that is just small enough to still be installed.

–	Check that ring is located »correctly« in groove.

SEAT Workshop Service and Repair Manuals