Leon Mk1
Engine - assembly overview |
1 - | Rear window |
q | Removing → Chapter. |
q | On installation, heed assembly direction -arrow- in detail view |
q | After inserting, slide window up so that distance -a- = 6.5mm from roof. |
q | Align windscreen glass at sides. |
2 - | Adhesive stopper strip |
q | Glue onto window next to bus bar → Anchor. |
q | Adhesive must not be allowed to come into contact with busbar for heated rear window |
3 - | Bead of glue |
q | Note differing distances from edge of windscreen: |
q | Distances -b- and -c- are obtained if nozzle is applied to inner edge of moulded surround in each case |
q | Distance from lower edge of window (dimension -d-) = 15 mm |
q | Cross-section of adhesive bead |
q | Bead width = 7 ± 12 mm |
q | Bead height = 11 ± 1 mm |
4 - | Spacers |
q | Observe different heights for standard or insulating glass |
q | Position spacers at a distance of 3 mm from lower edge of window on marks made in ceramic screen printed area |