WARNING Place airbag to one side such that SEAT emblem points upwards. |
|
WARNING t
| Follow safety regulations for pyrotechnic components. |
t
| Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling them must ensure that he/she is „electrically discharged“. for example by briefly grasping hold of door striker plate. |
|
–
| Have the plug connector -1- engage in its mount. The airbag connector must audibly engage. |
–
| Place the airbag unit in the assembly position. Fit by pressing first on the horizontal spoke area and then the vertical. |
Continue the assembly in the reverse order to removal, remembering to: |
–
| Switch off all electrical components. |
WARNING The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. |
|
Note If airbag warning lamp -K75- indicates a fault following installation, event memory must be read, cleared and read again → Vehicle diagnostic tester. |
|
|
|