SEAT Workshop Service and Repair Manuals > Leon Mk1 > Body | General body repairs, interior | Trim, noise insulation | Strut linings and side linings | B-pillar trim, 5-door vehicles and ST: Removing and installing.

B-pillar trim, 5-door vehicles and ST: Removing and installing.

Special tools and workshop equipment required

t	Release lever -T20043-

t	Torque wrench kit -SAT 8010-

Removal:

Note

Removal and assembly will be carried out taking into consideration small differences depending on the vehicle's equipment.

–	Remove front installation → Chapter.

–	Remove trim -2- from clip fasteners -3- on B-pillar.

–	Remove trim -2- downward.

–	Detach seatbelt -1- from trim -2-

–	Remove lining -2-

Installation

Installation is carried out in the reverse order. When installing, note the following:

Note

t	Before fitting the lining check the condition of the clips and replace if necessary.

t	After installation, check that trim is behind beading of door seal.

SEAT Workshop Service and Repair Manuals