t
| To install the selector lever handle -3- the button -2- has to be pulled out to the stop and must be secured with either a cable tie -arrow- or with the assembly aid supplied together with the new handle. |
t
| If, by mistake, the button has not been secured, it must not be pulled out of the selector lever handle using mechanical tools. Place a compressed air gun underneath the handle and make the button come out using compressed air. |
–
| Push the selector lever -3- fully onto selector lever. The button -2- must point to the driver. The handle must engage in the annular groove on the selector lever. |
–
| Remove the cable harness -arrow- or the assembly aid; the button mechanism is now inserted into the vertical groove of the selector lever. If necessary, the button must be inserted in the handle. |
–
| Pull sleeve -1- upwards and clip it in by turning it to the right. |
|
|
|