seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Repair notes > < Overview - components in the refrigerant circuits for front and rear seats

Leon Mk1

Fitting
Fitting
Installation is carried out in the reverse order of removing, when doing this note the following.
–  Check type of seal at connections and refrigerant pipes (must be designed for same type of seal) → Chapter and → Spare parts catalogue
–  Replace O-rings -B- and -E-; for version refer to → Spare parts catalogue
   
–  Tighten the bolts -B- to 10 Nm (bolts with M6 thread) and 25 Nm (bolts with M8 thread).
–  Tighten the bolt -A- to 10 Nm (bolts with M6 thread) and 25 Nm (bolts with M8 thread).
  Note
t  Tighten bolts -B- and then secure clip -C- with the bolt -A-.
t  Use is not to be made of O-ring seals from caps of replacement compressor connections.
  A87-0403
t  Following attachment, check routing of refrigerant pipes -A-. They must be inserted in holders -B- provided and not make contact with other components.
  A87-0404

Repair notes > < Overview - components in the refrigerant circuits for front and rear seats