Leon Mk1
|
1 - | Air distributor housing for air conditioning |
q | Do not dismantle further |
q | For those vehicles without an Additional heating element -Z35- the opening for the Additional heating element -Z35- is covered by the heat exchanger cover |
q | Lightly grease the support points and the temperature flap guides (for example using G 052 745 A3). |
q | Different versions in vehicles with manual and automatic climate control → Parts catalogue |
q | The air distribution casing in vehicles with manual climate control has gears with a cam disk for operating the air distribution flaps. Do not disconnect these gears as the adjustment cannot be reset. |
Note
t | Vehicles with manual climate control have the air distribution flaps operated manually via a flexible shaft. Vehicles with automatic climate control have air distribution flaps operated by servomotors. |
t | Vehicles with manual climate control have temperature flaps (right and left temperature flaps) connected to each other by an axle; they are operated by a servomotor. Vehicles with automatic climate control have left and right temperature flaps operated by independent servomotors. |
2 - | Bolt |
3 - | Air duct to the air vent in the left foot well |
q | Version “Climate control” |
4 - | Heating system heat exchanger |
q | Removing and fitting → Chapter |
5 - | Sealing ring |
q | Replace |
q | Lightly moisten with liquid coolant and fit correctly into place → Chapter |
6 - | Clip |
q | Replace |
q | Ensure that it is properly seated |
q | Removing and fitting → Chapter |
7 - | Bolt |
q | Tightening torque: 2.5 Nm |
8 - | Coolant tubes |
q | Remove and fit on the heat exchanger → Chapter |
9 - | Sponge material spacer |
q | Fitted between the grommet and the air conditioning unit |
10 - | Grommet |
q | Before fitting the climate control unit, fit this in the transversal panel of the vehicle → Chapter |
q | Fitting → Chapter |
11 - | O-ring |
q | Replace → Chapter |
q | Allocation → Parts catalogue |
12 - | O-ring |
q | Replace → Chapter |
q | Allocation → Parts catalogue |
13 - | Expansion valve |
q | Removing and refitting the refrigerant tubes → Chapter |
q | Removing and fitting → Chapter |
14 - | Bolt |
q | Tightening torque: 10 Nm |
q | Removing and fitting → Chapter |
15 - | Evaporator housing |
q | Deactivating and preparing → Chapter |
16 - | Dust and pollen filter |
q | Removing and fitting → Chapter |
q | Observe replacement intervals → Booklet |
17 - | Cover for the dust and pollen filter |
q | Removing and fitting → Chapter |
18 - | Air duct to the air vent in the right foot well |
q | Version “Climate control” |
19 - | Plug |
q | Only fitted to vehicles without air duct to rear vent of the centre console |