SEAT Workshop Service and Repair Manuals

Removing and installing cylinder head cover Removing → Anchor Installing → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-, see equivalent → Anchor

t  "1/4" Handle" -T20203A-, see equivalent → Anchor t  Sealant →  Parts catalogue

Removing –  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards. –  Remove upper toothed belt guard. –  Remove the crankshaft sump ventilation hose at the entry to the tube behind the supercharger air.

–  Unscrew the bolts for the cylinder head cover in the sequence -1... 11- unscrew and remove using the "1/4" handle" -T20203A-. Installing Continue the installation in the reverse order of removal sequence, observing the following:   Note If there is damage, replace the gasket and the cylinder head bolts.

–  Apply a drop of sealant →  Electronic spare parts catalogue (Ø approx. 5 mm) -arrows- to both sealing surface ends of the rear bearing cover / cylinder head.

–  Apply a drop of sealant →  Electronic spare parts catalogue (Ø approx. 5 mm) -arrows- to both sealing surface ends of the rear bearing cover / cylinder head.

–  Manually tighten the bolts for the cylinder head cover in the sequence -1 … 13- . –  Tighten the bolts to 10 Nm in the following order -1 ... 11-.