Leon Mk1
| Part II |
| 1 - | 120 Nm + retighten 1/4 turn (90°) + (30°) |
| q | Replace |
| q | To loosen and tighten, use the counter-support -T20018A- |
| q | The thread and the collar must be free from oil and grease |
| q | The retightening may be carried out in various stages |
| 2 - | 40 Nm + retighten 1/4 turn (90°) |
| q | Replace |
| 3 - | 15 Nm |
| 4 - | Lower protector of the toothed belt |
| 5 - | 10 Nm |
| 6 - | Central protector of the toothed belt |
| 7 - | Upper protector of the toothed belt |
| 8 - | Toothed belt |
| q | Before removing, mark the turning direction |
| q | Check for wear |
| q | Do not bend |
| q | Removal and refitting, tensioning → Chapter |
| 9 - | 25 Nm |
| q | Replace |
| 10 - | 20 Nm |
| 11 - | 20 Nm |
| 12 - | 40 Nm |
| 13 - | Camshaft pinion |
| q | Remove using extractor -T20119- |
| 14 - | Tensioner roller |
| q | Check the semiautomatic tensioner roller of the toothed belt → Chapter |
| 15 - | Return roller |
| 16 - | Injection pump pinion |
| q | Two pieces |
| 17 - | 30 Nm |
| 18 - | Rear protector of the toothed belt |
| 19 - | Coolant pump |
| q | Make sure it turns gently |
| q | Note the fitting position |
| q | For removal, it is necessary to remove the return roller |
| q | Removal and refitting → Chapter |
| 20 - | Return roller |
| 21 - | Toothed belt-crankshaft pinion |
| 22 - | Bushing |
| 23 - | Injection pump |
| q | Removal and refitting → Rep. Gr.23 |
| 24 - | Complete support |
| q | For injection pump, alternator and fin pump for power steering |
| q | For vehicles without air conditioning |
| q | Removing and refitting the compact support in vehicles with air conditioning: → Heating, air conditioning; Rep. Gr.87 |
| 25 - | 45 Nm |
