seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Renewing crankshaft oil seal -belt pulley end-

Leon Mk1

Removing
Removing
–  Remove ribbed belt → Chapter.
–  Remove toothed belt → Chapter.
–  Remove crankshaft sprocket. To do this hold sprocket with counter-hold -T20018-.
–  To guide seal extractor, screw securing bolt for crankshaft toothed belt sprocket into crankshaft onto stop by hand.
–  Unscrew inner part of the oil seal extractor -T20031- (32 mm Ø) out of the outer part.
   
–  Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
  E13-0046
–  Turn inner part against crankshaft until the oil seal is pulled out.
  E13-0049

Installing > < Renewing crankshaft oil seal -belt pulley end-