l
| Engine oil temperature must be at least 30 °C. |
–
| First remove ignition/HT. wiring cover. |
–
| Then pull off spark plug connectors and remove spark plugs using spark plug key -T20028-. |
–
| Pull connector off ignition distributor for Hall sender. |
–
| Use assistance of a second mechanic to depress accelerator fully. |
–
| Check compression pressures using tester -V.A.G 1381- or -V.A.G 1763-. |
Note! See respective operating instructions for description of how to use tester. |
–
| Operate starter motor until tester shows no further pressure increase. |
Compression pressure values: |
Permissible difference between all cylinders: 3 bar |
–
| Fit spark plugs with spark plug key -T20028- and tighten to 30 Nm. |
|
|
|