SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing parts of exhaust system >
< Exhaust gas recirculation valveN18 and Potentiometer for exhaust gas recirculationG212 Removing and installing
Leon Mk1
Power unit
4-cylinder engine (2-valve), mechanical stage
Exhaust system
Secondary air system
Combination valve for the secondary air system: Removing and installing
Combination valve for the secondary air system: Removing and installing
t
Removing
→ Anchor
t
Installing
→ Anchor
t
Tightening torques
→ Anchor
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda
→ Chapter
Special tools and workshop equipment required
t
Torque wrench -VAG 1331-, see equivalent
→ Anchor
.
Removing
–
Detach vent hose
-2-
leading to exhaust gas recirculation valve -N18-.
–
Disconnect the hose
-4-
from the crankshaft sump breather on the air duct.
–
Remove air pipe from
-1-
and
-3-
.
–
Remove bolts
-1-
.
–
Disconnect hose
-2-
from combination valve.
–
Detach combination valve.
Note
For improved understanding, it is shown from the rear in the illustration with engine removed.
Installing
Reassembly is carried out in the reverse order; note the following:
Note
t
Renew seals and gaskets.
t
Secure all screw joints with serial hose clips
→ Spare parts catalogue
.
Tightening torques
Components:
Nm
Combination valve to connecting flange
10
Power unit
4-cylinder engine (2-valve), mechanical stage
Exhaust system
Secondary air system
Removing and installing parts of exhaust system >
< Exhaust gas recirculation valveN18 and Potentiometer for exhaust gas recirculationG212 Removing and installing