–
| Cut the nozzle of the tube at the front mark (Ø nozzle: about 3 mm). |
–
| Apply the silicone-based sealant to the clean contact surface of the oil sump, proceeding as shown. Sealing compound bead must be: |
t
| Apply along the inner edge of the bolt holes -arrows-. |
Note The sealing compound bead must not be thicker, otherwise excessive sealing compound could enter the sump and block the oil suction pipe strainer. |
–
| Fit the oil sump immediately tightening all of the oil sump bolts slightly. |
–
| Tighten the bolts of the oil sump to 13 Nm. |
Note After fitting the oil sump, allow the sealant to dry for approx. 30 minutes. 30 minutes. After this time has passed, the engine oil may be filled. |
|
|
|