seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Engine brackets: adjustment

Leon Mk1

Engine and gearbox: Separate
Engine and gearbox: Separate
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Counterhold -T20186-, see equivalent → Anchor
  L00-10018
t  Workshop crane -VAS 6100-, see equivalent → Anchor
Premise
l  Engine/gearbox assembly removed and fixed on engine bracket -T20205-.
Operation process
–  Unscrew bolt -1- with gearbox fitted.
  W00-1214
–  Pull the cover plate -2- off upwards.
  Note
This is shown in the figure with the gearbox removed.
  A34-0234
–  Unscrew the bolts -1 … 8- on the flange between the engine and the gearbox.
–  Take out starter motor.
  Note
The gearbox is shown in illustration with engine removed.
  A37-0214
–  Place the support tool -T20186- on the gearbox, as shown in the illustration.
–  Carefully separate the gearbox from the engine, using the workshop crane.
  E10-10013

Enginecrankshaft group, pistons > < Engine brackets: adjustment