SEAT Workshop Service and Repair Manuals

Radiator: Removing and installing t  Removing → Anchor t  Fitting → Anchor t  Tightening torques → Anchor Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Tray -VAS 6208-

t  Pliers -VAS 6340- Removing   Note Collect drained coolant in a clean container for re-use or disposal.   WARNING Hot vapour/hot coolant may escape when opening expansion tank. Cover cap with cloth and open carefully. –  Open the cap of the coolant expansion tank.

–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.

–  Remove air hose (left side) for intercooler by lifting retaining clips -arrow- slightly. –  Bring lock carrier into service position: → General body repairs, exterior; Rep. Gr.50 –  Drain coolant → Chapter.

–  Remove air intake hose -arrow- from between lock carrier and air filter housing.

–  Unscrew air duct at lock carrier -arrows-.

–  Detach upper coolant hose -arrow- from radiator.

–  Pull out the plug -1-. –  Unscrew the bolts for the ventilator cowl -arrows- and remove the ventilator cowl downwards.

–  Unscrew bolts -arrows- of the radiator. –  Lift the radiator slightly then extract it upwards. Installing Fit in reverse order from removal, remembering the following:   Note t  Replace seals and O-rings. t  Secure all hose connections with the correct hose clips (original parts) → ETKA (Electronic parts catalogue). –  Install lock carrier: → General body installation work, exterior; Rep. Gr.50 –  Fill up coolant → Chapter. Tightening torques

Component	Nm
Radiator to intercooler	5
Fan cowl to radiator	5