seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gas recirculation system > < Particle filter for front wheel drive vehicles: Removing and installing

Leon Mk1

Exhaust gas temperature sender 2, bank 1G448: Removing and installing
Exhaust gas temperature sender 2, bank 1 -G448-: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor
t  Tightening torques → Anchor
   
Removing
–  Detach the outer -1- and inner -2- engine covers by pulling them evenly upwards.
  E10-10038
–  Separate the electrical connector -3- of the exhaust gas temperature sender 2, bedplate 1 -G448-, and move the cables to one side.
  A23-10003
–  Release the fuel and coolant hoses from their fittings on the air duct.
–  Remove bolt -1-.
–  Remove air duct by lifting retaining clips -arrows- slightly.
  A10-10266
–  Remove the exhaust gas temperature sender 2, bedplate 1 -G448--5-.
  Note
Disregard items -1 … 4-.
Installing
Continue the installation in the reverse order of removal sequence, observing the following:
  Note
Fit the cable clamps in the same position as they were.
–  When fitting, ensure that the bend of the exhaust gas temperature sender 2, bedplate 1 -G448--5- faces the left side of the vehicle, as shown in the diagram.
Fit the supercharger air system hoses and observe the assembly instructions → Chapter
Tightening torques
  A26-10173
ComponentNm
Exhaust gas temperature sender 2, bedplate 1 -G448- to particle filter45
Right air hose to bracket8

   

Exhaust gas recirculation system > < Particle filter for front wheel drive vehicles: Removing and installing