Exhaust system on vehicles with front-wheel drive |
Note t
| The connection element on the primary exhaust tube should not be bent more that 10 º, otherwise it may be damaged. |
t
| Exhaust manifold: removing and fitting → Chapter |
t
| Always gaskets and self-locking nuts. |
t
| After working on the exhaust system ensure that the system is not under stress, and that it has sufficient clearance from the bodywork. If necessary, loosen the double clamp and align silencers and exhaust pipe so that sufficient clearance is maintained to the bodywork at all points and the mountings are evenly loaded. |
t
| Loosen and tighten the tightening disks for the thermal protection plates with a screwdriver. Tightening torques: 2 Nm. |
t
| Front exhaust section with the particle filter - Components overview → Chapter |
t
| Particle filter for front wheel drive vehicles: removing and installing → Chapter |
t
| Stress-free alignment of exhaust system → Chapter |
|
|
|