Leon Mk1
|
Note
|
1 - | 8 Nm |
2 - | Exhaust gas pressure sensor 1 -G450- |
3 - | Bracket |
q | For pressure reading pipes at particle filter intake |
4 - | 10 Nm |
5 - | Pressure reading pipe at particle filter entrance, 45Nm |
6 - | Lambda sensor before catalytic converter -G39-, 50 Nm |
q | Removing and fitting → Chapter |
q | Only grease the thread with paste for high temperature bolts -G 052 112 A3- The paste must not get into the slots on the probe body. |
q | To remove and install use the lambda probe ring spanner -3337-. |
7 - | Exhaust gas temperature sensor 2, bedplate 1 -G448-, 45 Nm |
q | Grease the thread of the sensor with paste for high temperature bolts -G 052 112 A3- |
q | Removing and installing with the 17 mm wrench kit -T10395- |
8 - | Particulate filter for vehicles with front-wheel drive |
q | Removing and installing → Chapter |
9 - | Exhaust tube, front |
10 - | Mark |
q | Installation position of double clamp |
11 - | To primary silencer |
12 - | 25 Nm |
13 - | Suspension |
q | Replace if damaged |
14 - | Temperature sensor behind particle filter -G527- |
q | Grease the thread of the sensor with paste for high temperature bolts -G 052 112 A3- |
q | Removing and installing with the 17 mm wrench kit -T10395- |
15 - | From turbocharger |
16 - | Securing clip, 7 Nm |
17 - |
q | Gasket |
q | Replace. |
q | Note fitting position: |
18 - | 40 Nm |
19 - | Bracket |
q | Bolted to engine block |
|
3 - | Lambda probe -G39-
| ||||
4 - | Pressure hose towards exhaust gas pressure sensor 1 -G450-
| ||||
5 - | Exhaust gas temperature sender 2, bedplate 1 -G448-
|
Note
|
|
1 - | Temperature sensor behind particle filter -G527-
| ||||
2 - | Pressure hose towards exhaust gas pressure sensor 1 -G450-
|
|