Leon Mk1
|
1 - | Vehicle floor rear cross member |
2 - | Middle silencer |
q | In case of repairs, replace the factory fitted end silencer as one part |
q | Separating point → Chapter |
q | Align exhaust system without tension → Chapter. |
3 - | Suspension |
q | If this is damaged, replace it |
4 - | Mounting |
q | If this is damaged, replace it |
5 - | 25 Nm |
6 - | Mounting |
q | If this is damaged, replace it |
7 - | 25 Nm |
8 - | 25 Nm |
9 - | Support |
q | For particle filter |
10 - | 25 Nm |
11 - | Particulate filter for vehicles with front-wheel drive |
q | Mounting positions on the particle filter |
q | Removing and fitting → Chapter |
q | After replacing the particle filter, adjustment must be carried out with the “Guided Fault Finding” → Vehicle diagnosis, testing and information system VAS 5051. |
12 - | Gasket |
13 - | Securing clip - 7 Nm |
14 - | Double clamp, front |
q | Align exhaust system free from stress before tightening clamp → Chapter |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
15 - | 25 Nm |
16 - | Vehicle floor front cross member |
17 - | 25 Nm |
18 - | 25 Nm |
19 - | Double clamp, rear |
q | To replace centre and rear silencers separately |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
20 - | 25 Nm |
21 - | Suspension |
q | If this is damaged, replace it |
22 - | Rear silencer |
q | In the original factory equipment, this is a single piece with the centre silencer. In case of repair, replace separately |
q | Separating point → Chapter |
q | Align exhaust system without tension → Chapter. |
23 - | Mounting |
q | If this is damaged, replace it |
24 - | 25 Nm |
25 - | 25 Nm |
|
|