Leon Mk1
Exhaust gas recirculation- assembly overview |
1 - | 10 Nm |
2 - | exhaust gas recirculation radiator |
q | Removing and fitting → Chapter |
3 - | O-ring |
q | Replace. |
4 - | 10 Nm |
5 - | Exhaust gas recirculation valve -N18- with potentiometer for exhaust gas recirculation -G212- |
q | Before installation, check the sealing surface on the intake manifold for dirt, and clean it, if necessary |
q | When the exhaust gas recirculation valve -N18- with exhaust gas recirculation potentiometer -G212- has been replaced, the ignition must subsequently be turned on and off again. Then wait for a minute for the control unit run-on (valve learns, main relay must click in the process) |
q | Start the engine and let it run for at least one minute at idling speed |
q | Then interrogate the fault memory of the engine control unit, and there should be no fault registered in the fault memory → Chapter |
q | If a fault is registered in the fault memory, delete the fault memory and repeat the sequence of operations |
q | Removing and fitting → Chapter |
6 - | 22 Nm |
7 - | 10 Nm |
8 - | Intake manifold |
q | Removing and fitting → Chapter |
9 - | O-ring |
q | Replace. |
10 - | Gasket |
q | Replace. |
11 - | Intermediate hose |
12 - | O-ring |
q | Replace. |
13 - | Intake manifold flap motor -V157- |
q | Removing and fitting → Chapter |
14 - | 10 Nm |
15 - | Gasket |
q | Replace. |
16 - | 22 Nm |