seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust system on vehicles with four-wheel drive > < Exhaust gas recirculation system

Leon Mk1

Rear silencer: removing
Rear silencer: removing
t  In order to replace the centre and rear silencers separately, the connecting pipe can be cut at the marked point.
t  The cutting line is marked on the exhaust tube.
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Chain pipe cutter -VAS 6254-, see equivalent → Anchor
  A26-0790
Operation process
–  Cut through exhaust pipe at a right angle at cutting point -arrow 2- using chain-type pipe cutter -VAS 6254-.
–  When installing, position clamp -4- on the side marks -arrow 1- and -arrow 3-.
  A26-0732
–  Fit clamp so that ends of bolts do not protrude beyond bottom of clamp.
l  Bolted connection faces to rear.
–  Align exhaust system without tension → Chapter
  A26-0159

Exhaust system on vehicles with four-wheel drive > < Exhaust gas recirculation system