SEAT Workshop Service and Repair Manuals

Charge air cooler: Removing and installing t  Removing → Anchor t  Fitting → Anchor t  Tightening torques → Anchor Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Tightening torque -VAG 1331-, see equivalent → Anchor

t  Pliers -VAS 6340-, see equivalent → Anchor t  Centralising pin -T10093- Removing –  Unscrew the left and right hand side air pipes of the intercooler. –  Place the lock carrier plate into service position without mechanical components: →  Bodywork, exterior fitting work ; Rep. Gr.50. –  Remove the coolant radiator → Chapter.   WARNING The air conditioning cooling circuit must not be opened.

–  Undo the bolts -1- from the lock carrier plate to the intercooler.   Note To avoid damage to the flexible conduits/tubes of the cooling agent, the tubes must not be pulled, bent or stretched excessively.

–  Loosen the bolts of the condenser bracket -Arrow-.

–  Remove securing bolts -2- of condenser. –  Pull the radiator out upwards. Installing Fit in reverse order from removal, remembering the following: Fit the supercharger air system hoses and observe the assembly instructions → Chapter –  Fill up coolant → Chapter. Tightening torques

Component	Nm
Intercooler to the lock carrier plate	5
Condenser to the intercooler	5