Leon Mk1
Note
|
1 - | 10 Nm |
2 - | Support |
3 - | Heat shield |
4 - | Oil supply pipe, coupling nut, 22 Nm |
q | Check that the oil supply pipe is not obstructed before installing |
q | Before fitting, fill the turbocharger with engine oil through the connection of the oil feed tube |
5 - | Turbocharger |
q | Can only be replaced completely along with the exhaust manifold and the pressure capsule |
q | Before installing, fill turbocharger with engine oil at connection for oil supply pipe |
q | Removing and fitting → Chapter |
6 - | Vacuum hose |
7 - | Gasket |
q | Replace. |
q | Note fitting position: |
8 - | To the particle filter |
9 - | Clamp, 7 Nm |
q | For turbocharger/particle filter |
10 - | Exhaust manifold |
q | Replace only with turbocharger |
11 - | 25 Nm |
q | Replace. |
12 - | 25 Nm |
13 - | Gasket |
q | Replace. |
14 - | Connecting pipe |
q | For exhaust gas recirculation |
q | Exhaust gas recirculation radiator, assembly overview → Chapter |
15 - | 25 Nm |
q | Replace. |
16 - | 15 Nm |
17 - | O-ring |
q | Replace. |
18 - | Banjo bolt, 60 Nm |
19 - | Support plate |
q | For the exhaust gas turbocharger |
q | with oil backflow tube |
20 - | Exhaust gas temperature sender -1 -G235-, 45 Nm |
q | Grease the thread of the sensor with paste for high temperature bolts -G 052 112 A3- |
q | Removing and installing → Chapter |
21 - | Protector plate |
22 - | Joint mouth |
q | For air intake hose air filter/turbocharger |
q | Air filter - Component overview → Chapter |
23 - | 9 Nm |
24 - | 10 Nm |